Linux Bonding Configuration: Step-by-Step Guide

Configuring network bonding in Linux can be achieved by following these steps:

1. ifenslave is used to manage and configure network interfaces in Linux.

sudo apt-get install ifenslave

1. The configuration file for network settings: /etc/network/interfaces

auto bond0
iface bond0 inet static
    address <IP地址>
    netmask <子网掩码>
    gateway <网关地址>
    bond-slaves eth0 eth1
    bond-mode <绑定模式>
    bond-miimon 100
    bond-downdelay 200
    bond-updelay 200

“Among them, is the IP address of the binding interface, is the corresponding subnet mask, is the IP address of the gateway, eth0 and eth1 are the network cards that need to be bound, and can be one of active-backup, balance-rr, balance-xor, broadcast, 802.3ad, balance-tlb, or balance-alb.”

1. Restart the network service or reboot the system.

sudo /etc/init.d/networking restart

“Or”

sudo reboot

After the configuration is complete, the system will bind the specified network card and perform network transmission according to the specified mode. The success of the binding can be verified using the ifconfig command.