How do I mount the remaining disk space in OpenWrt?

To mount the remaining hard drive space, you can perform the following steps:

1. Make sure you have installed the appropriate drivers and file system support on your OpenWrt device.
2. You can connect to the command line interface of your OpenWrt device via SSH or serial connection.
3. Check your hard drive device using the following command to find the partition or disk you want to mount:

fdisk -l

1. Create a directory using the following command to serve as the mount point:

mkdir /mnt/mydisk

1. Mount the partition or disk to the mount point using the following command:

mount /dev/sdX /mnt/mydisk

/dev/sdX is the device name of the partition or disk you want to mount. For example, if you want to mount the first partition of the first hard drive, the device name may be /dev/sda1.

1. To check if the mounting was successful, you can use the following command:

df -h

You should be able to see the mount point (/mnt/mydisk) displayed as mounted on a certain device.

Please note that these commands may vary slightly depending on the version and configuration of OpenWrt. Make sure to follow the documentation for the OpenWrt version you are using and make any necessary adjustments as needed.